IMG_2102.JPG (Size: 95.09 KB / Downloads: 1)
Hello,This is my first build/ RC car in general and I have a simple question in regards to adjusting the endpoints. I was told the servo I bought has relatively high torque and I need to make sure I correctly make the EPA's. I read up on the manual on how to adjust these settings but what am I supposed to adjust them too? Every time I ask what I should adjust them too people answer "to the correct points" lol well thanks but what is a recommended save range to adjust them too? I am under the assumption that using this servo and allowing the car to slam full lock will burn out the gears in my servo relatively fast. Any help would be greatly appreciated as this is my last step before I can play with the car!
My electronics-
Futaba 3PL 2.4G FHSS R2004GF
BMS-621DMG+HS High Speed Digital Servo (Metal Gear)7.2kg / .10sec
Speed passions Reventon-s esc
v 3.0 Dokyo drift spec 10.5t-brushless/sensored motor
2 shorties. 2S- 90c- 4600 mAh 7.4 V and a universal charger Combo Special: Tenergy TB6-B Balance
Pic for attention.