Let me start by saying I'm pretty new to RC, especially electric. So I purchased the SP Reventon S with a 3.0 competition 10.5t sensored combo and am running a Bluebird 661 MG HS servo with an Eagle racing gyro. First issue I had was the ESC would go into heat cutoff mode after 1 minute. Checked gear lash and it seemed good. ESC wasn't even close to feeling hot. So I turned the heat shutoff feature off. Now I run the car and in about the same time period the servo gradually dies (like over 2 seconds rather than an immediate cut off), and the motor still runs at full speed. In researching I've learned the Reventon S and R have a low amp BEC. Is this the Issue and a external BEC should fix it? Or do I possibly have some faulty equipment? I'm using lipo 2s 25c 5000mah and they read over 7.4 when the issue happens. Transmitter is a flysky gt3. Any help would be much appreciated. Thanks.
↧